Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
by a factor (e.g. -1 for subtraction). Set inputs for terms you don't need to 0 (internal
constant); set all others to 1.
In the divider function two terms are divided. The dividend adds together up to three
terms, for each of which 2 inputs are multiplied; the divisor adds together up to three
inputs. Set inputs for terms you don't need to 0 (internal constant); set all others to 1.
Output = dividend/divisor
In addition to the "normal" division, a modulo division is carried out. This modulo divi-
sion checks how often the divisor is fully included in the dividend and determines the
Residual z. When you divide 11 by 4, for example, the 4 is included twice in 11, and 3 is
produced as the Residual z (2 x 4 = 8, 8 + 3 = 11).
If one of the source signals is invalid, all the output signals will become invalid as well.
The calculation will nevertheless be performed and the result exported. If the result is
outside the number range, NaN (not a number) is outputted.
7.4.2.12 Counter
Counts the edges (rising/falling/both) of a digital signal. Use Start/Stop with to inter-
rupt the count.
Timeout after: If you enter a time greater than 0, after that time the counter is reset if no
edge has occurred by then.
With Threshold Value for Flag you can set a flag when a specific count is reached.
Example:
Input signal
1
0
Abb. 50: Example for the counter function
If the maximum counter reading (10
and the counter stops. After a timeout or reset, the counter restarts.
92
Rising: 5
Falling: 6
Both: 11
Start/Stop
t
7
) is exceeded, the output signal becomes invalid
ClipX
Starting up the ClipX
Werbung
Inhaltsverzeichnis
