HBM ClipX Bedienungsanleitung Seite 90

Start by digital signals
Signal at
Input
0
1
0
1
0
1
0
1, 2
Abb. 49: Checkweigher, Start via digital signals
Specify a digital signal (digital input, limit switch or flag) for the Start Measure with and
Start Zeroing with conditions. As soon as a channel is entered here, any specified limit
value is ignored for the condition in question. The inputs are triggered by an edge from
Low (0) to High (1). A constant value deactivates the input.
Status
Value Explanation
1, 2 Wait for start of measurement or exceeding of limit value.
3 Wait for end of measurement delay.
4 Status during measuring time. When the measurement is complete, the
maximum, minimum, peak-to-peak and mean values are updated.
5 Wait for start of zero measurement or undershooting of limit value.
88
3 4
Meas. Meas.
Delay Time
Update of Maximum Value,
Minimum Value, Peak-to-Peak
and Mean
5 6
Zero Tracking
Delay
Measured Value
7 1, 2
Zero
Tracking
Time
Update Offset
Starting up the ClipX
t
Start Measure
Start Zeroing
Ready Flag
Status
ClipX