Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Qualified personnel
This device is only to be installed and used by qualified personnel (electricians or per-
sons trained in electrical engineering), strictly in accordance with the safety regulations
listed here. This includes personnel who meet at least one of the three following
requirements, depending on their assigned tasks:
•
Knowledge of the safety concepts of measurement and automation technology is a
requirement and as project personnel, they must be familiar with these concepts.
•
As measurement or automation system operating personnel, they have been
instructed how to use the equipment. They are familiar with the operation of the
equipment and technologies described in this document.
•
As commissioning engineers or service engineers, you have successfully com-
pleted the training to repair the automation systems. You are also authorized to
operate, ground and label circuits and equipment in accordance with safety engi-
neering standards.
Residual dangers
The ClipX system is a state-of-the art unit and as such is reliable. The scope of supply
and performance of the ClipX system covers only a small area of measurement technol-
ogy however. In addition, equipment planners, installers and operators should plan,
implement and respond to the safety engineering considerations of measurement tech-
nology in such a way as to minimize residual dangers. For example, automation equip-
ment and devices must be designed in such a way that adequate protection or locking
against unintentional actuation is provided (e.g. access controls, password protection,
etc.). When devices are working in a network, these networks must be designed in such
a way that malfunctions in individual nodes can be detected and shut down. Safety pre-
cautions must be taken both in terms of hardware and software, so that a line break or
other interruptions to signal transmission do not cause undefined states or loss of data
in the automation device.
Safety notice used in this document
Notice
This symbol draws your attention to a situation in which failure to comply with safety
requirements may result in damage to property.
6
ClipX
Safety instructions
Werbung
Inhaltsverzeichnis
