HBM ClipX Bedienungsanleitung Seite 159

9.6.4 Digital flags: List of I/O flags (I/O status)
The table below sets out the bits in the I/O status (64 bits). The bit is set if the relevant
status is active.
Bit Explanation
0 Digital input 1.
1 Digital input 2.
2 Digital input 1 debounced.
3 Digital input 2 debounced.
4 Digital output 1.
5 Digital output 2.
6 Digital output 1 delayed.
7 Digital output 2 delayed.
8 Result for limit value switch 1.
9 Result for limit value switch 2.
10 Result for limit value switch 3.
11 Result for limit value switch 4.
12 ... 19 Flags 1 to 8 of the calculated channels.
20 ... 29 Not in use.
30 Always 0.
31 Always 1.
32 ... 47 Flags 1 to 16 of the fieldbus.
48 ... 63 Flags 1 to 16 transmitted via Ethernet.
No output, i.e. not assigned. This is useful for unused flags, for exam-
64
ple, and is the default setting for calculations.
ClipX
Operation via fieldbus
I/O status
Low word
I/O status
High word
157