Connecting The Digital Inputs And Outputs - HBM ClipX Bedienungsanleitung

6.8

Connecting the digital inputs and outputs

The digital inputs and the flags or bits for the outputs are analyzed after 1 ms at the lat-
est in the event of a change.
See also „Available connections and LEDs" on page
Digital inputs
CxA
CxB
Sync Synchronization
DI2
DI1
DO2
DO1
0V
24V
Abb. 29: Plug terminal X2, pin assignment of digital inputs
The digital inputs must be switched against a positive voltage (≥10 V). An open input
will be detected as Low level (0).
52
Housing, cable shield optional
ClipX bus
X
ClipX bus GND
ClipX bus
DI
Digital In GND
Digital In 2
Digital In 1
Digital Out 2
Digital Out 1
Supply 0 V and Digital Out GND
Supply 10 ... 30 V
24.
LOW: 0 V ... 5 V
HIGH: 10 V ... 30 V
Electrical connections, LEDs
ClipX