Settings For The Fieldbuses; Settings For Profinet - HBM ClipX Bedienungsanleitung

Designation
Reply when
writing to the
object dictio-
nary
1)
The time is dependent on the update rate of the source signal.
The following table shows the bit assignment of the object value (value field) when
accessing the object dictionary.
Bit 31 ... 24
9.5

Settings for the fieldbuses

The following sections set out the settings you need to make in your web browser for
the respective fieldbuses.
See also „Connecting a web browser to the ClipX" on page
web browser" on page
9.5.1

Settings for PROFINET

In your browser, specify the device name (Name of Station). The name must be unique
within the network. It may also be easier to specify the IP Address and Netmask (subnet
mask) there. Click on
ClipX
Operation via fieldbus
Cycle in
Format
ms
UINT
(Index)
USINT
(Sub- 1
index)
USINT
(Error)
Bit 23 ... 16
Data object types UDINT, DINT, REAL, FLOAT
Not used
Not used
78.
APPLY
to apply the settings.
Explanation
Reply to the write request: The object has
been successfully written to if Index and
Subindex are identical to the request and
the error byte is zero.
Bit 15 ... 8
Data object types INT, UINT
68,
Bit 7 ... 0
Data object types
SINT, USINT
„Setting the ClipX using a
127