Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Abb. 10: Strain relief for double-shielded cable
For control cabinets, also place the outer shield on the cabinet input, using the shield
clamp shown above for example.
Single-shielded cables
Connect the shields of single-shielded cables to the connection for the housing (ground
symbol
, labeled "Outer cable shield" or "Cable shield" in the connection diagrams),
not to one of the GND connections (
). If you are using strain relief with a shield con-
S
nection clamp, insert the rigid pin into the connector for the outer cable shield (
) –
see figure below.
Abb. 11: Strain relief for single-shielded cable
ClipX
23
Electrical connections, LEDs
Werbung
Inhaltsverzeichnis
