Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Procedure for Windows 8/8.1
1.
From the Charms menu on the Windows desktop (not in tile view) open Settings ->
Control Panel -> Network and Sharing Center (display: Small icons) or Show net-
work status and tasks (View by: Categories).
2.
Click in the Show active networks area on the connection you want (usually LAN
connection).
3.
Click on Properties and specify an administrator account or confirm the confirma-
tion prompt.
4.
Select Internet protocol version 4 (TCP/IPv4) and click on Properties.
5.
Activate Use the following IP address and enter an address with which the first
three groups of numbers match the groups of numbers of the HBM device and only
the last group of numbers contains a different number between 1 and 254. The last
group of numbers must not match the one on the HBM device.
6.
For Subnet mask enter the same groups of numbers as are present on the HBM
device.
7.
Then click OK or Close to close all open dialogs.
See also
„Example" on page
Procedure for Windows 7
1.
From the Windows Start menu select Control panel -> Network and sharing center
(display: Small icons) or Show network status and tasks (View by: Categories).
2.
Click in the Show active networks area on the connection you want (usually LAN
connection).
3.
Click on Properties and specify an administrator account or confirm the confirma-
tion prompt.
4.
Select Internet protocol version 4 (TCP/IPv4) and click on Properties.
5.
Activate Use the following IP address and enter an address with which the first
three groups of numbers match the groups of numbers of the HBM device and only
the last group of numbers contains a different number between 1 and 254. The last
group of numbers must not match the one on the HBM device.
6.
For subnet mask enter the same digit groups as those available on the HBM device.
7.
Then click OK or Close to close all open dialogs.
See also
„Example" on page
ClipX
Starting up the ClipX
74.
74.
73
Werbung
Inhaltsverzeichnis
