HBM ClipX Bedienungsanleitung Seite 181

Index Subindex
0x4428 21 ... 26
0x4428 27
FIFO control flags
Bit Explanation for bit set
0
Fill trigger mode for continuous filling
values per second. Recording starts immediately with the specified number
of values per second, taking into account any differential conditions.
1
Fill trigger mode for status-controlled filling
the digital flags determines the filling, see
status)" on page
of the bits is set and an active difference condition is fulfilled.
2
Fill trigger mode for edge-controlled filling
digital flags determines the filling, see
status)" on page
sible signal sources if one of the bits changes and an active differential con-
dition is fulfilled. With this function, in contrast to the other mode of
operation, the change of only one bit from High to Low or from Low to High
several
with
8 Records 1 measured value each from all 6 possible signal sources immedi-
ately into the FIFO, even if the respective trigger condition is not fulfilled. The
value must be recorded together with one of the fill trigger modus status- or
edge-controlled filling, e.g. as 0x0102 or 0x0104. The current date and time
are stored as the start time and the time channel is set to 0. You should stop
a still running recording before the command and read out the FIFO memory,
since the FIFO memory is not deleted. The bit is deleted after execution.
ClipX
Operation via fieldbus
Function
Buffered measured value
from the FIFO channels 1 ...
6.
Buffered time from the
FIFO.
157. Filling is active if the result is not 0, i.e. if at least one
157. 1 measured value is recorded from each of the 6 pos-
already active bits (High) is also recognized as a trigger.
Value
FLOAT (Byte order Little
Endian), RO.
An invalid measured value is
always replaced by 1.001 *
30
10 ; any defined substitute
value is not used.
Time in ms since saving the
first value, UINT32, RO.
1)
of the FIFO with the set number of
1)
of the FIFO. The bit mask of
„Digital flags: List of I/O flags (I/O
1)
of the FIFO. The bit mask of the
„Digital flags: List of I/O flags (I/O
179