The Control Word - HBM ClipX Bedienungsanleitung

9.6.5

The control word

Setting a bit in the control word (Set command) triggers the function specified in the
table. However, all set functions are always executed, even if only one bit is changed. If,
for example, bit 1 (Tare) is already set, taring is triggered again on every change of one
of the other bits. The control word comprises 32 bits; the bits not listed here are
reserved for later upgrades.
The control word is acknowledged by ClipX – see
controller" on page
the action has been executed and you can delete the bit.
Bit
0 Zero (the gross value).
1 Tare (zero the net value).
2 Clear Zero Value (= 0).
3 Clear Tare Value (= 0).
4 Set the 1st point electrically in two-point scaling.
5 Set the 2nd point electrically of two-point scaling.
6 Hold Captured value 1.
7 Hold Captured value 2.
8 Delete Captured value 1.
9 Delete Captured value 2.
10 Reset Limit Switch 1.
11 Reset Limit Switch 2.
12 Reset Limit Switch 3.
13 Reset Limit Switch 4.
14 Reset maximum, minimum and peak-to-peak value.
Hold maximum, minimum and peak-to-peak value (as long as this bit is
15
set).
158
125. If the acknowledgment matches the transmitted control word,
„Data transfer from the ClipX to the
Function
ClipX
Operation via fieldbus