HBM ClipX Bedienungsanleitung Seite 83

Most calculations have only one or two outputs; the logic function NOT has 2 times 2
outputs; for the 6x6-matrix up to six outputs are possible. If the value is outside the dis-
playable number range, NaN (not a number) is outputted. If one of the input values is
invalid, the result is also flagged as invalid, though the calculation is normally per-
formed and the result outputted. For more information on this refer to the relevant cal-
culations.
DELETE
Click on
tion a different function type. To avoid accidental deletion, the button changes
CONFIRM DELETE
to
Sequence of calculations
The sequence of the functions at the top of the window decides when which calculation
is made. It does not matter which of the six function blocks you define the calculation
in. Change the sequence using
7.4.2.1 6x6 Matrix
Calculates six output signals from up to six input signals by means of a matrix. For x
x Select the input channels and for y
6
channels in order to output the relevant result channels.
You can use the calculation to compensate for the crosstalk of a multi-component force
transducer in the output signal. Enter only the coefficients (a
for unused coefficients. For example, if you do not need input x
to 0.
If one of the source signals is invalid, all the output signals will become invalid as well.
The calculation will nevertheless be performed and the result exported.
7.4.2.2 Tolerance window
The tolerance window combines several functions: Acquisition of minimum, maximum,
peak-to-peak and arithmetic mean and monitoring of exceeding/undershooting a limit
for a definable period of time. You can also determine the value of another channel
when an extreme value is reached.
ClipX
Starting up the ClipX
below the calculation formula to be able to assign a calcula-
, and you have to click it again.
UP
or
to y
1 6
DOWN
below the calculation formula.
select one of the six available calculated
xx
) in the dialog table. Use 0
, set every a (a
6 x6 16
to
1
to a )
66
81