Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2.4
Resetting Ethernet network settings (DHCP), enabling fixed IP address
You can reset the Ethernet network settings (and only them) to their factory defaults or
enable the fixed (static) IP address 192.168.0.234 (from firmware 2.0). In both cases
you must press the Reset button on the front of the ClipX while powering up.
You can also use the Reset button to temporarily disable user management
– see also
Abb. 41: System LED (1) and Reset button (2)
Resetting the Ethernet settings to their factory defaults (DHCP)
1.
Switch off the power supply.
2.
Press the Reset button (see picture) using a pencil or a small screwdriver and keep
it pressed while you switch the power back on.
3.
Wait for the system LED to start flickering green before releasing the button. The
ClipX then reboots.
4.
Wait for the reboot to complete before connecting to the device.
Ethernet port settings afterwards (factory defaults)
•
Use DHCP ("Obtain an IP address automatically", meaning from the server or via
APIPA, i.e. negotiate in the network, if your PC is also using DHCP).
•
Device name: ClipX.
•
All manual IP address, subnet mask, gateway or DNS settings are cleared.
ClipX
Starting up the ClipX
„User Management" on page
77.
75
Werbung
Inhaltsverzeichnis
