HBM ClipX Bedienungsanleitung Seite 40

Strain gage full or half bridge and piezo-resistive sensors in 6-wire configuration with
Zero-Wire TEDS, version for D-sub-HD15
The solder terminals on this TEDS module are not labeled. You must connect the sensor
leads on the side with the four contact surfaces (in the picture on the top of the mod-
ule). The contacts represented with dashed lines are on the bottom of the TEDS module.
Connect the + and - sense leads there.
Pt100
TEDS
4
1
2'
2
3'
3
I
U
Abb. 18: Plug terminal X4, pin assignment in 6-wire configuration with Zero-Wire TEDS,
version for D-sub-HD15; with half bridge, connector 4 is omitted
38
S
Inner cable shield
Measurement signal −
Measurement signal +
Sense lead −
Bridge excitation voltage −
Sense lead +
Bridge excitation voltage +
Outer cable shield
AI
Zero-Wire-TEDS
Cable wire colors (HBM transducer):
bu = blue; gn = green; gy = gray;
rd = red; bk = black; wh = white;
rd
wh
2
bk
gy
1
bu
gn
3
Electrical connections, LEDs
4
ClipX