Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Status/error
Error factory calibra-
tion
Test signal active
Ethernet connection
established
Reserved
PPMP connected
PPMP error
Reserved
Reading TEDS
Error TEDS
Heartbeat
ClipX
Operation via fieldbus
Bit
Explanation for bit set
19
There is an error in the calibration of the ClipX.
Make a note of the error type and contact HBM
„Technical support" on page
20
The test signal is activated, no measured values are
captured.
21
A TCP/IP connection has been made via Ethernet, to
transfer data or make settings for example. This is
not the connection to a browser.
22
Not in use, and reserved for future upgrades.
23
A PPMP connection via Ethernet has been estab-
lished.
24
There is an error in the PPMP connection; the sys-
tem LED is lit yellow.
25 ...
Not in use, and reserved for future upgrades.
28
29
The TEDS module is being read and the device is
being configured according to the specified set-
tings.
30
The data in the TEDS module either contain errors
or cannot be set.
31
The bit is switched on and off rhythmically at
0.5 Hz, indicating that the ClipX is working.
231.
155
Werbung
Inhaltsverzeichnis
