HBM ClipX Bedienungsanleitung Seite 128

Designation
External Eth.
value 1
External Eth.
value 2
Analog out-
put
I/O-Status
low
I/O status
high
Measured
value status
Control word
Parameter
set number
Reply when
reading from
the object
dictionary
126
Cycle in
Format
ms
FLOAT 1
FLOAT
0.52 ... 1
UDINT
1
UDINT
UDINT
0.52...1
UDINT 1
Event-
UINT con-
trolled
UINT
(Index)
USINT
(Sub-
index)
USINT
1
(Error)
UDINT
(Value)
Explanation
Value 1 transmitted via Ethernet.
Value 2 transmitted via Ethernet.
Value of the analog output in V or mA.
1)
See „Digital flags: List of I/O flags (I/O sta-
tus)" on page
See „Measured value status: List of status
1)
bits" on page
The echo of the control word – see section
headed „Data transfer from the controller to
the ClipX" on page
tion has been triggered when the received
control word is equal to the one sent.
The number of the active parameter set.
Reply to the read request: The value is valid
if Index and Subindex are identical to the
request and the error byte is zero.
Value of the reply. The value type is defined
as UDINT, but REAL values (FLOAT) are also
returned. To do so, copy the value without a
type conversion (cast operation) from value!
The table below explains the bit assign-
ment.
157.
152.
122. The desired func-
Operation via fieldbus
ClipX