Available Connections And Leds - HBM ClipX Bedienungsanleitung

For control cabinets, also place the shield on the cabinet input, using the shield clamp
shown above for example.
Grounding
Important: You must ground the support rail on which you mount the ClipX.
If you want to mount the ClipX in a different way, such as on a wall, you must
ground the housing by way of the mount.
6.3

Available connections and LEDs

Abb. 12: Locations of the connections and LEDs; the connector designations X1 to X7
are imprinted on the housing; for meanings see table.
No. Description
1 X1: Ethernet port
2 X2: Supply voltage, Digital I/O, ClipX bus
3 X3: Analog output
4 X4: Transducer connection, TEDS
24
Electrical connections, LEDs
ClipX