HBM ClipX Bedienungsanleitung Seite 162

Example
Abb. 62: Example of an object list (excerpt)
Term Explanation
Idx Index (16 bit), 0x0000 ... 0xffff in hexadecimal format.
SubIdx Subindex (8 bit), 0 ... 255 in decimal format.
Type Data type, see also
Access W: Write
R: Read
RO: Read only
WO: Write only
S: Changing possible by changing parameter set
Y: Cyclic change.
The following tables list only RO and WO. Commands with no specification
are RW.
Tips
For the dynamic calculation objects the best sequence of generating them is:
1. Set up the calculated channels via the web interface or write the desired block types
to objects 0x5001.1 ... 6.
2. Generate the object list as described above. This list then contains all the required
dynamic objects.
3. Edit the objects using your PC-based or PLC program.
If you are uncertain about any setting, use your web browser to make it. Then read
out the value via the relevant object in the object dictionary.
160
„Data types used by the ClipX" on page 121.
ClipX
Operation via fieldbus