Object Dictionary - HBM ClipX Bedienungsanleitung

Bit
16 Filter fast-track. The filter output jumps to the input value.
Save current settings to current parameter set (corresponds to the
17
button in the Parameter Sets menu).
9.7

Object dictionary

For most applications, the cyclic data that can be transmitted over the respective field-
bus are sufficient. For special applications, the object dictionary is available. You can
use it to access all the settings of a ClipX. You can use the object directory with the
fieldbuses or via Ethernet or with OPC UA.
See also „Data transfer from the controller to the ClipX" on page
from the ClipX to the controller" on page
on page 103. You will find DPV1 objects in the
section.
The object dictionary is not the EtherCAT object dictionary. The EtherCAT
objects are only visible for the EtherCAT master.
Dynamic objects
Some objects are created or disappear during the runtime: The objects in the range
0x5100 ... 0x57FF are dynamic objects which are dependent on the creation or deletion
of calculated channels. The objects of the function block at position 1 have the index
0x5101, those of the block at position 2 the index 0x5102 etc. The index of the objects in
a block changes when you move it to a different position.
Object list
You can download an (unsorted) object list for the current configuration via your
browser's Device Storage menu: "clipx_od.csv". The columns are separated by semico-
lons. As a new list is generated for downloading, it takes a few seconds for the process
to complete and the download to start.
ClipX
Operation via fieldbus
Function
125, „Operation via Ethernet/OPC UA/PPMP"
„Settings for PROFIBUS" on page 130
SAVE
122, „Data transfer
159