Mounting; Mounting On A Support Rail - HBM ClipX Bedienungsanleitung

M
5
OUNTING
The ClipX is designed for mounting on a support rail (35 mm DIN rail to DIN EN 60715).
You can choose different mounting methods if you want though. The support rail on
which you mount the ClipX may be 8.5 or 16 mm deep.
Important: You must ground the support rail.
5.1

Mounting on a support rail

Abb. 3: Mounting on a support rail
1. Hang the ClipX from the top edge of the support rail.
2. Push the ClipX onto the support rail in the direction of the arrow as shown in the
picture.
The clip at the bottom secures the ClipX by a spring.
ClipX

Mounting

15