Safety Instructions; Safety Rules - HBM TIM-PN Montageanleitung

1

Safety instructions

TIM-PN
The TIM-PN torque interface module must only be used
for torque measurement tasks in combination with T40
family torque flanges from Hottinger Baldwin Messtechnik
GmbH and for directly associated control and regulating
tasks. Use for any purpose other than the above is
deemed to be non-designated use.
In the interests of safety, the module must only be used
as described in the operating manual. It is also essential
to comply with the legal and safety requirements for the
application concerned during use. The same applies to
the use of accessories.
The interface module is not a safety element as defined
by its intended use. For safe and trouble-free operation,
this module must not only be correctly transported,
stored, sited and mounted, but must also be carefully
operated.
1.1

Safety rules

The module must be operated with a separated extra-low
voltage (supply voltage DC 18 to 30 V DC).
Before commissioning, make sure that the mains voltage
and type of current match the mains voltage and type of
current at the place of operation and that the circuit used
is sufficiently protected. Connecting electrical devices to
low voltage: only separated extra-low voltage may be
used (safety isolating transformer according to
DIN VDE 0551 / EN 60742). Do not operate the device if
the supply lead is damaged. Only operate built-in devices
once they are installed in the housing provided. The
device complies with the safety requirements of
DIN EN 61010 - Part 1 (VDE 0411 - part 1); protection
class I. The module must be mounted on a support rail
A4341-2.0 HBM: public
Safety instructions
5