Inhaltsverzeichnis
Werbung
maintenance personnel.
Therefore, the warning notes refer to both, operation and maintenance personnel of the drill-
ing- milling machine.
WARNING!
Always disconnect the drilling- milling machine from the electrical power supply. This will pre-
vent it from being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The user must have been instructed by the operator about the assigned tasks and possible
risks in case of improper behaviour. The user may only carry out tasks that exceed normal
operation if this is stated in these instructions and the operator has explicitly entrusted him with
the task.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Instructed person
Instructed persons were instructed by the operating company regarding the assigned tasks and
any possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
and strictly follow these operating instructions.
In the event of improper use
there may be a risk to personnel,
there may be a risk of damage to the drilling- milling machine and other material values,
the correct function of the drilling- milling machine may be affected.
1.6.2
Authorized persons
WARNING!
Inappropriate operation and maintenance of the milling machine constitutes a danger to
the personnel, objects and the environment.
Only authorized personnel may operate the milling machine !
Authorized operating and maintenance personnel are specialists instructed and trained by the
operator and the manufacturer.
1.6.3
Obligations of the operating company
The operator must instruct personnel at least once a year in
Version 1.0.1 - 2021-11-18
Translation of original instruction
MB4
EN
53
Werbung
Inhaltsverzeichnis
