Operation; Safety; Control And Indicating Elements - Optimum OPTImill MH 25 SV Betriebsanleitung

4

Operation

4.1

Safety

Place the milling machine in operation only under the following conditions:
The milling machine is in proper working order.

The milling machine is used as intended.

The operating manual is followed.

All safety devices are installed and activated.

Eliminate or have all malfunctions rectified promptly. Stop the milling machine immediately in
the event of any abnormality in operation and make sure it cannot be started up accidentally or
without authorisation.

"For your own safety during operation" on page 63
4.2

Control and indicating elements

Pos. Designation
Control panel
1

"Control panel" on page 74
3 Hand crank for raising/lowering the milling head
5 - 6 Hand crank for cross table
Version 1.0.1 dated 2015-12-17
4
6
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
3
7
Pos. Designation
Digital position indicator
2

"DRO 5" on page 81
4 Spindle protection
7 Opening Tool quick clamping system
2
1
5
MH25SV GB
Page 73