Personal Protective Equipment - Optimum OPTidrill DH 40CT Betriebsanleitung


once a week (with the machine in operation) and

after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the drilling milling
machine

are legible (clean them, if necessary)

are complete.
INFORMATION
Organise the checks according to the following table;
General check
Equipment
Guards
Drill chuck guard
Signs,
Markers
Date:
Functional check
Equipment
Emergency-stop push
button
Spindle protection
Date:
1.11

Personal protective equipment

For some works you need personnel protective equipment as protective equipment. These are

safety helmet,

protective glasses or face guard,

protective gloves,

safety shoes with steel toe caps,

ear protection.

hairnet.
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Soiled personal protection equipment that may be contaminated may cause illness.
Clean your personal protective equipment

after each use,

regularly once a week.
Safety
Version 1.0.1 - 2021-07-06
Check
Mounted, firmly bolted and not damaged
Installed and legible
Checked by (signature):
Check
After the emergency stop button is pressed, the drilling milling
machine must switch off.
It must not be possible to switch on the drilling milling machine
until the spindle guard is closed.
Checked by (signature):
Translation of original instruction
OK
OK
DH 40CT EN
63