Siemens SINUMERIK840D sl Handbuch Seite 1928

Inhaltsverzeichnis
2.11.2 Signale von NC (DB10).......................................................................................................... 2-114
2.12 Planachsen (P1)..................................................................................................................... 2-114
2.13 PLC-Grundprogramm (P3)..................................................................................................... 2-114
2.14 Referenzpunktfahren (R1)...................................................................................................... 2-115
2.14.1 Signale an Kanal (DB21, ...)................................................................................................... 2-115
2.14.2 Signale von Kanal (DB21, ...)................................................................................................. 2-116
2.14.3 Signale an Achse/Spindel (DB31, ...)..................................................................................... 2-117
2.14.4 Signale von Achse/Spindel (DB31, ...)................................................................................... 2-118
2.15 Spindeln (S1) ......................................................................................................................... 2-119
2.15.1 Signale an Achse/Spindel (DB31, ...)..................................................................................... 2-119
2.15.2 Signale von Achse/Spindel (DB31, ...)................................................................................... 2-127
2.16 Vorschübe (V1) ...................................................................................................................... 2-134
2.16.1 Signale an Kanal (DB21, ...)................................................................................................... 2-134
2.16.2 Signale an Achse/Spindel (DB31, ...)..................................................................................... 2-143
2.16.3 Signale von Achse/Spindel (DB31, ...)................................................................................... 2-150
2.17 Werkzeugkorrektur (W1) ........................................................................................................ 2-150
Index................................................................................................................................................ Index-1
iv
Funktionshandbuch, Ausgabe 03/2006, 6FC5397-0BP10-1AA0
NC/PLC-Nahtstellensignale (Z1)