Videohub Routing Using Sdi; Videohub Master Control Pro - Blackmagic Design Videohub Master Control Pro Installations- Und Bedienungsanleitung

Videohub Routing using SDI

Once your Videohub hardware control panel is connected to a Videohub on your network,
you can use the front panel buttons to switch routes. This section of the manual shows how to
switch a simple SDI route using Videohub Master Control Pro and Videohub Smart Control Pro.

Videohub Master Control Pro

Videohub Master Control Pro's front panel features source and destination buttons, plus a spin
knob. Use these controls to switch a basic route.
To Switch a route:
1 Press the 'dest' button to enable the destination output selection.
SRC CLEAR
LEVEL DEST
2 Use the spin knob to scroll through the available destination outputs.
SRC CLEAR
LEVEL DEST
3 Now press the 'src' button to enable the source input selection.
SRC CLEAR
LEVEL DEST
4 Use the spin knob to select a source input. When the source is selected, the 'take' button
will flash indicating that you can confirm the route by pressing 'take', if you want to cancel
the route press 'clear'.
TAKE
TAKE
TAKE
Videohub Routing using SDI 8