Blackmagic Design Videohub Master Control Pro Installations- Und Bedienungsanleitung Seite 11
Steuerpanel
Vorschau ausblenden
Andere Handbücher für Videohub Master Control Pro:
- Installations- und bedienungsanleitung (834 Seiten) ,
- Installations- und bedienungsanleitung (364 Seiten)
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NMOS Controller Setup
You can configure your Videohub hardware control panel as an NMOS controller in the 'control
panel' tab of Blackmagic Videohub Setup. This is a setup utility that is used to configure your
hardware panel as a Videohub or NMOS controller, label your Videohub's buttons and update
the unit. Download the Videohub software for free at the Blackmagic Design Support Center
at
www.blackmagicdesign.com/support
Once you have downloaded and installed the Videohub software, connect your Videohub
hardware control panel to your computer via USB and launch Blackmagic Videohub Setup.
You will see your Videohub control panel on the setup utility's home page. Clicking on the
image of your control panel or the settings icon will open the panel's configuration page.
In the 'controller settings' of the 'control panel' tab, select 'NMOS controller' by clicking on its
respective radio button.
If you're using Videohub Master Control Pro, you can start routing 2110 IP video right away.
Videohub Smart Control Pro requires a little more setting up using Blackmagic Videohub Setup
software before you can start routing 2110 IP video. Refer to the 'getting started' section for how
to configure the buttons for Videohub Smart Control Pro.
Using NMOS Control
11
Werbung
