Blackmagic Design Videohub Master Control Pro Installations- Und Bedienungsanleitung Seite 39

Up to 16 crosspoint routes can be changed by a single macro
Take Button
When the 'enable take button' checkbox is active, the lower right button on the control interface
turns red. Use this if you want a confirmation option to come up before your route change takes
place. Press the 'take' button to confirm your route change. The 'take' button can be used with
both cut bus and XY controller configurations and can also be used with macros.
The Take button illuminates red in the lower right corner
Backlight
Adjust the backlight slider to vary the brightness of the backlit buttons as desired. Enable
'backlight destinations only' if you wish to disable the backlighting of the white source buttons.
Videohub Hardware Panel Setup 39