Blackmagic Design Videohub Master Control Pro Installations- Und Bedienungsanleitung Seite 21

If you need to visually identify your Videohub hardware control panel, for example in an
equipment rack, click the 'identify' button. When selected, the buttons on the front of the panel
will flash white.
Network Settings
Network Location and MAC address
The network location is the name for your Videohub control panel that will appear in the
registry. This is based on the identification name at the top of the setup utility. It's worth noting
that numeric prefixes will be ignored.
The MAC address is a hardware identifier that is unique to your Videohub control panel.
This is important when setting up network security systems that only allow equipment that can
be identified by a MAC address. You can easily select the MAC address for copying
and pasting.
Protocol
Each Videohub hardware control panel requires an IP address to communicate with Videohubs
on your network.
When configuring a Videohub control panel via USB, you can choose DHCP or Static IP.
DHCP automatically obtains all the network settings for your Videohub control panel and
is the easier choice.
If you decide to use a static IP address, please ask your system administrator for a spare IP
address to avoid creating a conflict on your network. You will then need to complete the IP
address, subnet mask and gateway details for your Videohub control panel. You must use a
static IP address if you are connecting directly to an Ethernet-equipped Videohub, such as
Smart Videohub 20x20, without using a network switch.
Allow utility administration
Enabling the 'via USB' setting limits setting changes to only the computer connected via USB.
This removes the risk of anyone on the network making accidental settings changes.
NMOS Registry
The NMOS registry IP can be entered manually or check auto to automatically discover the
NMOS registry on the network.
Reset
Click 'factory reset' to restore your Videohub control panel to factory settings. Once you press
'set', you will be prompted to confirm your selection. To proceed, click 'reset'.
Blackmagic Videohub Setup 21