Manual Functions - ECOLAB LMIT09 DPV1 Betriebsanleitung

Operation

Manual functions

The manual functions can be used to simulate the output current I
(temperature) and to switch the alarm relay on and off.
9
Fig. 48: Service – Manual Functions
1. Select the menu (
ð Service is called and Manual Functions is shown with a grey background
(inverted).
2.
Press the 'Enter'
3. The first function - Current (IC) (item 2) - is pre-selected, and the first two digits can
be set using the
Setting range: 00-22
4. Press the 'Right'
set these in the same way with the
Setting range: 00-99.
5.
You can then select the second function - Current IT (item 8) - using the 'Right'
arrow button and set the first two digits using the
range: 00-22
6. Press the 'Right'
and set these in the same way with the
Setting range: 00-99.
7. The third function - Alarm Relay (item 14) - can then be selected using the 'Right'
arrow button. The operation of the relay can be switched ON or OFF via the
corresponding settings. Setting range: ON or OFF.
417101561 Rev. 4-06.2021
1
8
10
Ä 8.8 'Service' on page 83).
button (item 1) to call the Manual Functions submenu.
and buttons (item 3).
arrow button (item 4) to move to the two last digits (item 5) and
arrow button (item 10) to move to the two last digits (item 11)
2
4
3
11
12 13
or button (item 6).
or
or button (item 12).
84
(conductivity) and I
C T
5
7
6
14
button (item 9). Setting