Transport; Repairs/Returns To Ecolab Engineering Gmbh - ECOLAB LMIT09 DPV1 Betriebsanleitung

1.2

Transport

NOTICE!
Material damage due to improper transportation!
Transport units can fall or tip over if improperly transported. This can cause
a large amount of damage. When unloading the shipping crates, during
delivery or even during general shipping, proceed safely and pay attention
to the symbols and the information on the packaging.
Danger of putting into operation a piece of transport equipment which
has been damaged during transport:
If damages are discovered during unpacking, do not install or put unit into
operation, as otherwise uncontrollable faults can occur.
Transport inspection:
Examine delivery for completeness and transportation damages and report
every damage. Damage claims can only be filed within the applicable
period for complaints.
In event of transportation damages visible from the outside:
Do not accept the delivery or accept provisionally. Note the extent of
damage on transport documents Delivery note of the carrier and initiate
a complaint immediately.
The measurements of the packaging and the weight of the packaging can be found online
Ä 11 'Technical Data' on page 101.
see
1.3

Repairs/returns to Ecolab Engineering GmbH

DANGER!
Conditions for returns
Before returning all parts must be completely free of chemicals! We
would like to point out that only clean, rinsed and chemical-free parts
can be accepted by our service!
This is the only way to exclude the risk of injury to our staff from residual
chemical products. The goods sent in must, as it is possible, be additionally
packed in a suitable bag that prevents residual moisture from leaking into
the outer packaging. Enclose a copy of the product data sheet of the
chemical used so that our service staff can prepare for the use of the
necessary protective equipment (PPE).
7
General
417101561 Rev. 4-06.2021