ECOLAB LMIT09 DPV1 Betriebsanleitung Seite 177

Operation
Setting the product table
NOTICE!
Up to four product tables can be defined. So that they can be selected
at a later stage, the measuring mode must be set to 'Concentration'
in the set of parameters and the relevant product (customer 1 - 4)
must be selected. The (minimum) distance between two entered points
is 0.1 (% or mS/cm). Only curves with a positive slope are permitted
(concentration and conductivity).
These settings must be made only by Ecolab employees with the
required knowledge and authorisations.
Example of a customer product curve (4 sampling points)
Illustration
Concentration [weight %]
Overview of Parameters - Set Product Table
C
E
Fig. 27: Overview: Setting the product table
A Main menu
B Parameters menu
C Configuration Set Product Table / Customer
Selection
417101561 Rev. 4-06.2021
B
A
D
Concentration Conductivity
0.0 % 0.00 mS/cm
1.0 % 10.00 mS/cm
2.0 % 20.00 mS/cm
3.0 % 30.00 mS/cm
D Configuration of Customer
E Configuration of Customer / Table
F Reset table to factory settings
64
F