ECOLAB LMIT09 DPV1 Betriebsanleitung Seite 198

Calling Manual Functions - Factory defaults
1
Fig. 49: Service - Factory Defaults
1. Select the menu (
ð Service is called and Manual Functions is shown with a grey background
(inverted).
2. Press the 'Down'
ð The Factory defaults submenu (item 2) is displayed in grey (inverted).
3. Press the 'Enter'
4).
Only Settings
Selecting Only Settings, resets the configuration, parameters and the armature factor
to their factory defaults.
1
Fig. 50: Service – Factory Defaults – Only Settings
1. Select the menu (
ð Factory defaults is called and Only Settings (item 1) is displayed in grey
(inverted).
2. Press the 'Enter'
ð The screen displays a confirmation prompt, which is set to NO by default (item 3)
to prevent data from being deleted accidentally.
3. Use the arrow buttons (item 4) to switch between No (item 3) and Yes (item 5).
4.
Use the button (item 6) to confirm the required setting.
ð
Choosing Yes (item 5) deletes the data and an active access code.
The screen returns to the factory defaults, as described under
Manual Functions - Factory defaults' on page 85.
2
Ä 8.8 'Service' on page 83).
button (item 1).
button (item 3) to call the Factory defaults submenu (item
2 6
Ä 8.8 'Service' on page 83).
button (item 2) to call the Only Settings selection screen.
85
3
3 5
4
417101561 Rev. 4-06.2021
Operation
4
Ä 'Calling