Basic Settings - ECOLAB LMIT09 DPV1 Betriebsanleitung

1. Call the main menu by pressing the left button (for approx. 4–5 seconds).
(See also
2. The upper menu level Basic settings (item 2) is displayed in inverted form.
3. Press the 'Down'
ð The inversion within the menu moves to Parameters.
Press the 'Down'
Calibration. All steps outlined below are the same for both Parameters and
Calibration.
4. Press (item 4).
ð A prompt asking you to enter a Passnumber is displayed.
The first number of the 4-digit code is displayed in inverted form.
5. Use the
6.
Then press the 'Right'
set.
7.
Press the 'Enter'
ð If the code entered is correct, the display returns to the original display and the
areas that were previously blocked ( ) are now accessible( ).
8.5

Basic settings

NOTICE!
For space reasons, some of the menu items are displayed on several
pages in the graphics display.
The
to move between the individual menu items.
Calling the basic settings
Call the Main Menu see:
Press the 'Enter'
(item G). The Language menu item is shown with a grey background
(inverted) when you access the menu.
Ä 8.4 'Main menu' on page 46)
button (item 3).
button again to change the inverted selection to
(item 5) or (item 6) buttons to set the number.
arrow button (item 7) to switch to the next number to be
button (item 8) to confirm your selection.
and/or buttons or
Ä 8.4 'Main menu' on page 46
button to item call the Basic Settings submenu
and/or
49
Operation
buttons can be used
417101561 Rev. 4-06.2021