ECOLAB LMIT09 DPV1 Betriebsanleitung Seite 201

Operation
All Data
'All Data' is used to reset or delete all the settings and data described in
Manual Functions - Factory defaults' on page 85.
Fig. 53: Service – Factory defaults – All Data
1. Select the menu (
ð Factory defaults is called and Only Settings (item 1) is displayed in grey
(inverted).
2. Press the 'Down'
ð The All Data submenu (item 3) is displayed in grey (inverted).
3. Press the 'Enter'
ð The screen displays a confirmation prompt, which is set to NO by default (item 5)
to prevent data from being deleted accidentally.
4. Use the arrow buttons (item 6) to switch between No (item 5) and Yes (item 7).
5. Use the
ð
The screen returns to the factory defaults, as described under
Manual Functions - Factory defaults' on page 85.
417101561 Rev. 4-06.2021
1
2
Ä 8.8 'Service' on page 83).
button (item 2) three times.
button (item 4) to call the All Data selection screen.
button (item 8) to confirm the required setting.
Choosing Yes (item 5) deletes the data.
3
4
8
88
Ä 'Calling
5 7
6
Ä 'Calling