Prophete GENIESSER Bedienungsanleitung Seite 142

DRIVE SYSTEM
OPERATE THE DRIVE SYSTEM
The drive system assists you whilst pedalling with additional motor power up to a speed of 25 km/h.
You can freely choose between the assistance levels
1. Select the desired assistance level with the Plus
ing.
The higher the selected assistance level, the greater the motor assistance. The speed to be reached
depends to a large extent on various factors, such as:
- total weight (including rider and luggage),
- tyre pressure,
- gradient or incline,
- condition of the ground,
- wind conditions.
For systems with mid-mounted motor, the maximum assisted speed also depends on the gear en-
gaged. The higher the engaged gear, the higher the assisted speed by the mid-mounted motor.
If you stop pedalling whilst riding, the motor switches off automatically after a short delay.
You can ride the e-bike like a normal bicycle with the drive system switched off or with assistance
level at "0" (no LED
193
DRIVING BEHAVIOUR WITH MOTOR ASSISTANCE
The driving behaviour of an e-bike with active motor assistance is sometimes very different from that
of a bicycle.
You should therefore adapt the assistance level of the motor to the outside environment (e.g. road
surface, traffic density, surface conditions), the speed and your own capabilities. For example, use ei-
ther a low level of assistance or no assistance at all when driving into tight bends or when driving at
a slow speed.
PUSHING AID
With the pushing aid you can accelerate the e-bike up to a speed of no more than 6 km/h without any
pedal movement.
1. Stand on the left-hand side of the e-bike.
2. Select the pushing aid with the Minus button
3. Now keep the minus button
must continue to flash). If the button
the motor then stops automatically.
EN 54
lights up).
pressed down until the pushing aid activates. (The LEDs
190
190
(0-5 LEDs) at any time:
193
or Minus button
191
until the 1st-5th LED flashes
190
is released prematurely and the pedals aren't moving,
before or whilst driv-
190
.
193
193