Prophete GENIESSER Bedienungsanleitung Seite 136

DRIVE SYSTEM
of a bicycle.
You should therefore adapt the assistance level of the motor to the outside environment (e.g. road
surface, traffic density, surface conditions), the speed and your own capabilities. For example, use ei-
ther a low level of assistance or no assistance at all when driving into tight bends or when driving at
a slow speed.
PUSHING AID
With the pushing aid you can accelerate the e-bike up to a speed of no more than 6 km/h without any
pedal movement.
1. Stand on the left-hand side of the e-bike.
2. Select the pushing aid with the Minus button
3. While the push assist symbol is displayed, keep the button
push assist. If the button
then stops automatically.
SETTING MODE
Activate the setting mode as follows:
1. Press the and
150
The setting mode allows you to make the following settings:
TRIP RESET (TRIP)
UNIT (U)
BL
CLOCK
AUTO OFF (AU)
LIGHT ALWAYS ON (LI)
COMING HOME (CO)
MAINTENANCE (MA)
ERROR MEMORY (ERR)
Use the buttons (-) and
150
You can exit the setting mode at any time by pressing the
time for 2 seconds.
EN 48
is released prematurely and the pedals aren't moving, the motor
150
buttons at the same time for 2 seconds to access the setting mode.
151
Reset the distance cyclometer (yes = reset)
Switch between kilometres (Metric) and miles (Imperial))
Set the display brightness (1-4)
Set the time
Automatic shutting down of e-bike when not in use (OFF/3/5/10)
Continuous light (on/off)
Switch-off time for the lighting after the system is switched of (OFF/5/10/20)
Reset the maintenance notice
History of error messages
(+) to select the individual items and confirm with the
151
in the display field
150 161
pressed down to activate the
150
(-) und (+) buttons at the same
150 151
.
button.
153