Prophete GENIESSER Bedienungsanleitung Seite 140

DRIVE SYSTEM
DRIVING BEHAVIOUR WITH MOTOR ASSISTANCE
The driving behaviour of an e-bike with active motor assistance is sometimes very different from that
of a bicycle.
You should therefore adapt the assistance level of the motor to the outside environment (e.g. road
surface, traffic density, surface conditions), the speed and your own capabilities. For example, use ei-
ther a low level of assistance or no assistance at all when driving into tight bends or when driving at
a slow speed.
PUSHING AID
With the pushing aid you can accelerate the e-bike up to a speed of no more than 6 km/h without any
pedal movement.
1. Stand on the left-hand side of the e-bike.
2. Select the pushing aid with the Minus button
3. While the push assist symbol is displayed, keep the button
push assist. If the button
then stops automatically.
SETTING MODE
Activate the setting mode as follows:
1. Press the and
170
The setting mode allows you to make the following settings:
TRIP RESET (TRIP)
UNIT (U)
BL
CLOCK
AUTO OFF (AU)
LIGHT ALWAYS ON (LI)
COMING HOME (CO)
MAINTENANCE (MA)
ERROR MEMORY (ERR)
Use the buttons (-) and
170
You can exit the setting mode at any time by pressing the
time for 2 seconds.
EN 52
is released prematurely and the pedals aren't moving, the motor
170
buttons at the same time for 2 seconds to access the setting mode.
172
Reset the distance cyclometer (yes = reset)
Switch between kilometres (Metric) and miles (Imperial))
Set the display (daylight) brightness (1-4)
Set the time
Automatic shutting down of e-bike when not in use (OFF/3/5/10)
Continuous light (on/off) ON: Light = permanently on | OFF: Light = sensor controlled
Switch-off time for the lighting after the system is switched of (OFF/5/10/20)
Reset the maintenance notice
History of error messages
(+) to select the individual items and confirm with the
172
in the display field
170 182
pressed down to activate the
170
(-) und (+) buttons at the same
170 172
.
button.
171