Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
And here's how it's done:
•
After calling up the desired navigation receiver to program a shuttle stretch operated by
another, (for example in track X) you will have in the display LNCV0 with the module-
address, the cursor will be blinking at position 0
•
Select LNCV-Nr. 2 for the operation style
•
Continue with the [→]-key to enter the operation type number
•
Enter the operation type number 5 (shuttle stretch controlled by another)
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select LNCV-Nr. 3 for the active direction
•
Continue with the [→]-key to enter
•
Enter the value 0 for direction S1->S2 similarly 1 for direction S2->S1, this will depend
on which way round you installed your sensors
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select LNCV-Nr. 4 for the waiting time
•
Continue with the [→]-key to enter the waiting time
•
Enter the waiting time in seconds from 0 to 255
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select LNCV-Nr. 6 for the signal address, which should be observed at the exit
•
Continue with the [→]-key to enter the signal address
•
Enter the signal address X
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select LNCV-Nr. 7 for the signal address of the parallel track
•
Continue with the [→]-key to enter the signal address of the parallel track
•
Enter the signal address with its switching direction 1, i.e. signal 27 green: enter 271
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Once the programming is complete, exit with the [menu] key, or step by step with the
[←] key.
Extended Functions
The basic function as described above can be extended by programming additional LNCVs:
Electrical accessories and routes in general
With LNCV8 you have the extra possibility to enter a switching command for an electrical
accessory or route. This command will be executed as soon as the sensors are run over, irre-
spective of the vehicle address, which means that all vehicles will switch the same electrical
accessory or route.
LNCV
Name
8
Access./route
Individual switching operation
Chapter 8.2 is concerned with the individual switching operation, and how the vehicle can
change individual vehicle functions, speeds or switch electrical accessories. All of the swit-
Description
Address and direction of the second accessory to be
switched, this means that 0 or 1 is added to the address,
similarly the address of a route or feed-back
133
Werbung
Kapitel
Inhaltsverzeichnis
