FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch Seite 171

8 2nd. Address
for electrical
accessories,
routes
(in MEMO),
feedback
9 Block-speed
for red signal
10 Block free
Value: 0
1-255
257-511
11 Switch
automation
on/off using
a signal
12 Automation
on/off using
category
Value: 0
11-14
For automatic operations 4-10 and 20-26 as per LNCV2
here can be given a 2nd. address of an accessory a route
or feedback address. The corresponding command will be
transmitted when the sensor is run over.
Otherwise as per LNCV 7
This value will be sent to the central controller if the exit
signal is set to „red" and a loco comes across a sensor.
0=Halt (factory setting), 1=emergency stop, 2-127=speed
steps (display in TWIN-CENTER: 1-126). If a value greater
than 1 is entered here, the destination sensor (i.e. entry 2,
if the programmed direction is from 1 to 2) can be twice on
the route. It therefore serves as speed measure and to
execute automatic functions. If the train brakes approaching
a red signal and reaches the 2nd sensor, then the speed will
be set to zero (targeted braking). Both the sensors are
connected to one terminal of the module. The targeted
braking can be used in the operation styles 4-10 and 20-26.
Chapter 8.4.2
Options for the block condition from „occupied" to „free",
see also chapter 8.4.5.
The block condition will be changed from „occupied"
to „free", if a train in the block section starts off or runs
through and subsequently sets the block exit signal (LNCV6)
to „red" (factory setting)
The block condition will be changed from „occupied" to
„free", if a train in the block section stars off or runs through
and the given number of seconds delay has elapsed
In addition to the previous setting, the exit signal will be set
to „red" as per LNCV6
Signal address (factory setting 0), with which the automatic
functions can be switched on or off, chapter 8.4.3:
Signal red: Navigation receiver is not active
Signal green: Navigation receiver is active
(The signal does not need to really exist, but must be
registered in the TWIN-CENTER)
For operation styles 4-10 and 20-26, controlling the
automatic operation by the categories of the navigation
transmitter, chapter 8.4.4
No control of automation by categories (factory setting)
1-4 (for categories 1 to 4): according to the recognised category
and the value entered here, the automatic operation will not
be carried out
(for categories 1 to 4): the automatic operation will solely
be carried out by the recognised category
171