Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
And here's how it's done:
•
After calling up the desired navigation receiver to program a station stop, (for example
at signal X) you will have in the display LNCV0 with the module-address, the cursor will
be blinking at position 0
•
Select LNCV-Nr. 2 for the style of operation
•
Continue with the [→]-key to enter the operation style number
•
Enter the operation style number 6 (station stop)
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select the LNCV-Nr. 3 for the active direction
•
Continue with the [→]-key to enter
•
Enter the value 0 for direction Sensor 1 -> Sensor 2, 1 for direction Sensor 2-> Sensor
1 or 2 for both directions
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select the LNCV-Nr. 4 for the waiting time
•
Continue with the [→]-key to enter the waiting time
•
Enter the waiting time in seconds from 0 to 255
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select LNCV-Nr. 6 for the signal address which is to be observed on the exit
•
Continue with the [→]-key to enter the signal address
•
Enter the signal address X
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Once the programming is complete, exit using the [menu] key or step by step using the
[←] key.
Extended Functions
The basic function as described above can be extended by programming additional LNCVs:
Electrical accessories and routes in general
With LNCV7 and LNCV8 you have two extra possibilities to enter a switching command for
an electrical accessory or route. These commands will be executed as soon as the sensors
are run over, irrespective of the vehicle address, which means that all vehicles will switch the
same electrical accessory or route.
LNCV
Name
7
1. Accessory/
route
8
2. Accessory/
route
Individual switching operation
Chapter 8.2 is concerned with the individual switching operation, and how the vehicle can
change individual vehicle functions, speeds or switch electrical accessories. All of the swit-
ching functions as described there can also be individually programmed in to the automatic
station stop operation.
Description
Address and direction of the first accessory to be switched,
this means that 0 or 1 is added to the address, similarly the
address of a route or feed-back
Address and direction of the second accessory to be
switched, this means that 0 or 1 is added to the address,
similarly the address of a route or feed-back
137
Werbung
Kapitel
Inhaltsverzeichnis
