Loco Special Functions: Determine Sequence - FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch

And here's how it's done:
• Press the [menu]-key
• Press the [mode]-key
• Using the [↓]-key, scroll down to the entry (LocoNet Prog.)
• Continue with the [→]-key
• Enter the article number (6833)
• Confirm with the [↵] key
• Enter the module-address, confirm with the [↵] key
• LNCV0 will be displayed with the module-address
• Enter the address-LNCV-Nr., i.e. 80
• Continue with the [→]-key to address entry
• Enter the address, i.e. 94
• Confirm with the [↵] key
• Using the [←] key go back to LNCV-selection
• Enter the value-LNCV-Nr., i.e. 90
• Continue with the [→]-key to value entry
• Enter the value, i.e. 560
• Confirm with the [↵] key
• Using the [←] key, go back to LNCV-selection
• Enter the mode-LNCV-Nr., i.e. 100
• Continue with the [→]-key to mode entry
• Enter the mode, i.e. 2
• Confirm with the [↵] key
• Using the [←] key, go back to LNCV-selection
• Repeat the procedure of LNCV-programming for LNCV 81,91,101 and so on
• Once the programming is complete, exit by using the [menu] key or step by step with
the [←] key.

8.2.5 Loco special functions: Determine sequence

New with receiver software from version 28/06:
Activate loco's special functions (light/sound...) in desired sequence at departure in
front of a signal
Old: At departure in front of a green signal the tables for electrical accessories, velocities and
functions were executed in a fixed sequence.
New: Now it is possible, to define an individual sequence of the loco's special functions
(light/sound...) at departure in front of a signal. That way you get a more realistic operation.
For example, after a signal has turned green, at first some sounds shall be executed and only
after that, the loco should depart.
This we achieved by inserting five function positions (pos. 0 to 4) into the existing sequence
of departure at a green signal. Here the counting starts with zero (0), because the function in
pos. 0 was put in front of the existing sequence.
122