FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch Seite 123

The start-sequence of any loco now looks basically like that:
Sequence at start
old new
Pos. 0
1
Pos. 1
2
Pos. 2
3
Pos. 3
4
Pos. 4
The selection, at which position (0 to 4) of the above mentioned start-sequence a loco
special function shall be inserted, is made in the special function mode (see TRAIN-
NAVIGATION manual chap. 8.2.3), which is programmed within the LNCVs 40...49 of your
TRAIN-NAVIGATION-receiver.
The Table for the modes of the function commands acc. to chap. 8.2.3 of the manual thus
was altered and now looks as follows:
Mode for function commands:
Mode
Direction (of travel)
Direction assessment
Function implementation
in automatic operation
Switch: on/off/change
Switch period for on/off
Lapse of time
Position selection
of special functions
The figures in column "Value" of the chosen respective functions you now must add
together and fill that sum in as Mode in the Table of switch functions.
Funktions
Are there any loco special function commands to send?
Are there electrical accessories, routes or feedback
messages to send?
Are here any loco special function commands to send?
Is a waiting time according to LNCV5 programmed?
Are here any loco special function commends to send?
Is a loco-individual waiting time for that loco
programmed?
Are here any loco special function commands to send?
Is an individual speed alteration to send?
Are here any loco special function commands to send?
Selection
from Sensor 1 to Sensor 2
from Sensor 2 to Sensor 1
no, the direction is irrelevant
yes, refer to direction
when running over a sensor
when starting off
switch off
switch on
change to another condition
none
on/off to corresponding lapse of time
none
1 s
2 s
4 s
8 s
16 s
Position 0:
Position 1:
Position 2:
Position 3:
Position 4:
If yes,
then
execute
execute
execute
wait
execute
wait
execute
execute
execute
Value
0
1
0
2
0
4
0
8
10
0
32
0
256
512
1024
2048
4096
0
8192
16384
24576
32768
123