Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Extended programming description (see manual chapter 8.3.5.3):
LNCV
Name
120
Track
occupation
indicator
121
Route
122
Entry signal
123
Previous block
Example:
The run-through track is valid with a red run-through signal 11 (S11) only for the loco wea-
ring address 100.
If the run-through signal 11 is switched to green, all trains arriving will take the run-through
track.
Program listing:
Station track 1
LNCV
Value Note
0
3
Module address
1
2
23
Track manager
3
0
Direction of travel S1 > S2
4
5
0
Elec. accessory waiting time
6
9
Monitor exit signal S9
7
200
Set entry signal S20 to red
8
0
Set signal of previous block to green
9
0
10
261
Set exit signal automatically after 5 s to red
Value
Description
0
Ghost address of a TRAIN-NAVIGATION-receiver
(which is not real existing on the layout), over which
the entry manager defines the occupancy state of
the run-through track. Range of values: 1...4095.
No other TRAIN-NAVIGATION-receiver must have
that address!
0
Route from the station entry (block with the entry
manager) to the station exit (block with the exit
manager) used for the complete passing by of the
station. Range of values: 0...20483
0
Set signal at the entry manager to "red"
0
Set signal at the block prior to the entry manager
to "green"
157
Werbung
Kapitel
Inhaltsverzeichnis
