Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• •
(0) in switching operation, where
• •
(0) function f1 is switched off
• •
(32) the switching off will last for a defined time lapse
• •
(4096) The time lapse will take 16 seconds, and then will be automatically switched
on again
Therefore Mode = 0+2+0+0+32+4096 = 4130
Advice
• If you switch off the referral back to direction, then the selection of the direction from
sensor 1 to sensor 2 or vice-versa from sensor 2 to sensor 1 has no meaning, there-
fore similarly no direction needs to be programmed in
• By using 2 single sensors at different locations, then the referral back to direction is
basically switched off anyway
And here's how it's done:
•
Press the [menu]-key
•
Press the [mode]-key
•
Using the [↓]-key, scroll down until the entry (LocoNet Prog.)
•
Continue with the [→]-key
•
Enter the article-number (6833)
•
Confirm with the [↵] key
•
Enter the module-address, then confirm with the [↵] key
•
LNCV0 will be displayed with the module-address
•
Enter the address-LNCV-Nr., i.e. 20
•
Continue with the [→]-key to the address entry
•
Enter the address, i.e. 20000
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Enter the value-LNCV-Nr., i.e. 30
•
Continue with the [→]-key to value entry
•
Enter the value, i.e. 33
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Enter the mode-LNCV-Nr., i.e. 40
•
Continue with the [→]-key to mode entry
•
Enter the mode, i.e. 16
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Repeat the LNCV-programming for LNCV 21,31,41 and 22,32,42 and so on
•
Once programming is complete, exit using the [menu] key or step by step with the [←]
key.
8.2.4 Electrical Accessories, Routes and Feedback
The 10 commands to switch individual electrically operated accessories (points, signals) or
even whole routes of points or also to get feedback, are entered in the LNCVs 80 to 109.
Thus giving:
LNCV 80 – 89:
Vehicle addresses, which will carry out the commands
LNCV 90 – 99:
Values to switch electrical accessories, routes or feedback
LNCV 100 – 109: Mode for electrical accessory switching functions
118
Werbung
Kapitel
Inhaltsverzeichnis
