FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch Seite 142

The selected routes may not necessarily be ready and the points could still be changing. In
order to give a time delay, an additional waiting time can be entered in LNCV5, so that the
navigation receiver waits before sending out the accessory or route commands until the
speed commands have first been executed.
LNCV Name
5 Accessory wait
For receivers from software version, 28/06, see also page 130 ("New for receivers from
software version 28/06").
If the block section is set to run through (the signal at the exit end of the block is green), then
the delay will be according to LNCV5. Individually programmed electrical accessories or rou-
tes will still be activated.
Basically the execution of the commands of the individual switching operations is carried out
according to the following sequence:
1. Are there electrical accessories/route commands to transmit? If yes: execute
2. If the signal according to LNCV6 is set at red, wait for the programmed time as per LNCV5
3. Are there individual speed commands to transmit, if yes: execute immediately, provided
that signal as per LNCV6 shows green. If the signal is red however, execute the individual
speed commands when starting off again.
4. Are there individual function commands to transmit? If yes: execute
Example: Block System
Diagram 17: Block system
142
Value Description
0 – 255 Waiting time to execute the accessory/route, entry
in seconds
Fahrtrichtung
Direction of travel