Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The following sequence will be carried out by the navigation receivers in the right push-pull
position:
•
A loco (it doesn't matter which) runs past the red signal X coming from behind
•
The loco runs over the sensors of the navigation receiver
•
The loco brakes with its own inertia setting to a halt
•
It waits for a while, the same waiting time is valid for all vehicles
•
Signal X will be set to green
•
The loco sets off again in the opposite direction reaching its original speed setting.
In order to achieve this sequence, then the following LNCVs should be programmed:
LNCV
Name
0
Module address
1
2. Sensoraddr.
2
Operation style
3
Direction
4
Waiting time
6
Signal address
And here's how it's done:
•
After calling up the desired navigation receiver, you will have in the display LNCV0 with
the module-address, the cursor will be blinking at the 0 position
•
Select the LNCV-Nr. 2 for the operation style
•
Continue with the [→]-key until the entry operation style number
•
Enter the operation style number 4 (time controlled shuttle)
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select the LNCV-Nr. 3 for the active direction
•
Continue with the [→]-key to the entry
•
Enter the value 0 for direction S1->S2 or similarly 1 for direction S2->S1, which will be
dependent on which way round you have installed the sensors.
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select the LNCV-Nr. 4 for the waiting time
•
Continue with the [→]-key to put in the waiting time
•
Enter the waiting time in seconds from 0 to 255
•
Confirm with the [↵] key
•
Using the [←] key, go back to LNCV-selection
•
Select the LNCV-Nr. 6 for the signal address
•
Continue with the [→]-key to enter the signal address
•
Enter the signal address X
•
Confirm with the [↵] key
126
Value
Description
Module address of the navigation receiver, 1– 4095
0
Will not be used (double-sensor)
4
Time controlled end position for the shuttle
Direction in which the navigation receiver will be
active:
0
from Sensor 1 to Sensor 2,
1
from Sensor 2 to Sensor 1
The navigation receiver will not react when the
sensors are run over in the opposite direction
0 – 255
Waiting time is settable from 0 – 255s
X
This signal will be automatically be set by the
navigation receiver. It need not even be actually
on the layout, but must be registered in the
TWIN-CENTER.
Werbung
Kapitel
Inhaltsverzeichnis
