FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch Seite 170

3 Direction
Value: 0
4 Waiting time
5 Waiting time
for electrical
accessory
sequences
6 Signal address
(exit signal)
7 1st. Address
for electrical
accessories,
routes
(in MEMO),
feedback
Value:
10, 20, 30, - 20000 Set electrical accessory 1, 2, 3, - 2000 to red / curve,
11, 21, 31, - 20001 Set electrical accessory 1, 2, 3, - 2000 to green / straight,
20010 - 20241
12, 22, 32, - 20482 Report feedback address 1, 2, 3, - 2048 as FREE,
13, 23 ,33, - 20483 Report feedback address 1, 2, 3, - 2048 as OCCUPIED,
170
96 Delete the operation value (automatically given in the course
of operation) Programmed LNCVs will not be altered,
chapter 8.4.1
97 Delete all LNCVs of the switching operation (from LNCV20),
chapter 8.4.1
98 Delete all LNCVs except addresses (LNCV1, LNCV2),
chapter 8.4.1
99 Re-instate factory settings, without altering addresses,
chapter 8.4.1
LNCV2=2
LNCV20=20000
LNCV30=1
LNCV40=2
Direction, in which the automatic operation styles 4-10 and
20-26 as per LNCV2 is active, chapter 8.3
Automatic active for direction Sensor 1 -> Sensor 2
(factory setting)
1 Automatic active for direction Sensor 2 -> Sensor 1
2 Automatic active in both directions: only for station stop
Waiting time for operation style 4: shuttle and operation
style 6: station stop, 0-255s, (factory setting 0),
chapter 8.3.1, 8.3.3
Waiting time after switching the loco individual routes and
before the waiting loco starts again. Valid for all operation
types 4-10 and 20-26; 0-255s, (factory setting 0),
chapter 8.3
Address of the exit signal (factory setting 0)
for operation styles 4-10 and 20-26, chapter 8.3
Operation style 4, 6, 20, 22: signal set from module.
Operation style 5, 7-10, 21, 23-26: signal will be observed
for train halt
This signal in automatic operation must always be given
For automatic operations 4-10 and 20-26 as per LNCV2
here can be given a 1st. address of an accessory a route or
feedback address. The corresponding command will be
transmitted when the sensor is run over.
0 No address command will be transmitted (factory setting)
chapter 8.2.4
chapter 8.2.4
Switch TWIN-CENTER-routes (MEMO), addresses
see chapter 8.2.4
chapter 8.4.6
chapter 8.4.6
LNCV21=20000
LNCV31=1
LNCV41=11