Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Navigation receiver track X:
LNCV
Name
0
Module address
1
2. Sensor addr.
2
Operation style
3
Direction
4
Waiting time
6
Signal shuttle
stretch
7
Signal Parallel
track
Navigation receiver track Y
LNCV
Name
0
Module address
1
2. Sensoraddr.
2
Operation style
3
Direction
4
Waiting time
6
Signal shuttle
stretch
7
Signal Parallel
track
Advice
As we have already learned from chapter 8.2.4, in LNCV7 a figure "1" is always added
to the address for the signal in order to set the signal to green. If however, the LNCV7
had the value 381 for example, then this would mean: set signal 38 to green.
132
Value
Description
Module address of the navigation receiver, 1 – 4095
0
Will not be used (double-sensor)
5
End position for shuttle controlled by another
Direction which will be active in the navigation
receiver:
0
from Sensor 1 to Sensor 2
1
from Sensor 2 to Sensor 1
If the sensors are run over in the opposite direction
the navigation receiver will not react
0 – 255 Waiting time (in seconds) settable, before the
navigation receiver begins, to observe the condition
of signal as per LNCV6
X
The signal X will be observed, until the signal
is set to green again. It need not actually be on
the layout, but it must be registered in the
TWIN-CENTER
Y1
The signal Y will be automatically set to green
by the navigation receiver. It need not actually
be on the layout, but it must be registered in the
TWIN-CENTER
Value
Description
Module address of the navigation receiver
0
Will not be used (double-sensor)
5
End position for shuttle controlled by another
Direction which will be active in the navigation
receiver:
0
from Sensor 1 to Sensor 2
1
from Sensor 2 to Sensor 1
If the sensors are run over in the opposite direction
the navigation receiver will not react
0 – 255 Waiting time (in seconds) settable, before the
navigation receiver begins, to observe the condition
of signal as per LNCV6
Y
The signal Y will be observed, until the signal
is set to green again. It need not actually be on
the layout, but it must be registered in the
TWIN-CENTER
X1
The signal X will automatically be set to green
by the navigation receiver. It need not actually
be on the layout, but it must be registered in the
TWIN-CENTER.
Werbung
Kapitel
Inhaltsverzeichnis
