Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Navigation Transmitter
4.1
Technical Data
The navigation transmitter is a high-value, electronic circuit which is protected by a trans-
parent lacquer. This lacquer protects the navigation transmitter from the dirt around its open
mounting under the vehicle, but at the same time allows through the infra-red light to trans-
mit the digital information.
Data:
•
Size: 13,5 x 9 x 2,5 mm
•
Short addresses, pre-set: 3 (active)
•
Long addresses, pre-set: 2000 (passive)
•
Loco-addresses 1 – 9999
•
Wagon-addresses 10000 – 16382
•
Four category indications 1 – 4
•
Programmable with DCC direct mode (CV-Programming) bit- and bytewise as well as
DCC register mode
•
Maximum distance from rail surface 12 mm
4.2
Installation
When installing the navigation transmitter please handle the delicate electronic components
with care, as explained in the preface in chapter 1!
Fasten the navigation transmitter under your digital locomotive using the accompanying
double-sided adhesive tape. The adhesive tape should be fixed to the flat side of the navi-
gation transmitter (without electronic components). The side of the navigation transmitter
with components must point downwards (towards the track). If there is insufficient space
under a loco (particularly in N gauge), then you can mount the navigation transmitter under
a wagon, which you must then permanently allocate to the loco.
Especially when mounting in a wagon, you must ensure that there will be good power pick-
up to the vehicle. For example, if the vehicle runs with no flicker on the interior lighting, then
the navigation transmitter can be installed without any problems.
Diagram 3: Installation
98
Werbung
Kapitel
Inhaltsverzeichnis
