FLEISCHMANN TRAIN-NAVIGATION6893 Handbuch Seite 102

through the holes in the track and finally press the plastic clips with the sensors into the
holes in the track. Two sensors built into the track in this way we call „double sensors".
Please make sure when installing the sensors that they do not protrude over the top of the
height of the rails. When installed correctly, the sensor heads should lie approx. 0,5 mm dee-
per than the rail height and is therefore protected against damage by track rubbers, etc.
Please make sure that there is no obstruction under the location, like a frame support, which
will cause a problem for the holes to be drilled through. Also make sure that there are now
wires in the way under the baseboard that could be damaged by the drill.
Diagram 5: Installation of the Sensors
The wires of the sensors are 60 cm long. Please make sure that when installing the sensors,
that an accompanying navigation receiver can be mounted under the layout less than 60 cm
away.
Advice
Keep the wires of the sensors away from track feed wires of electrical accessory wires
to prevent any cross interference.
102
Bohrschablone
Drilling guide